Frank

Frank

1
Follower
5
Following
Frank
More ideas from Frank
There was no room in my basement shop to cut full sheets of plywood. I always had to have the home center guy cut it down to size with his panel saw. What a hassle. I wanted my own panel saw, but I knew there was simply no room in my shop or budget. Then I came up with the solution: a lightweight, fold-down … #woodworkingtools #woodsaw

There was no room in my basement shop to cut full sheets of plywood. I always had to have the home center guy cut it down to size with his panel saw. What a hassle. I wanted my own panel saw, but I knew there was simply no room in my shop or budget. Then I came up with the solution: a lightweight, fold-down … #woodworkingtools #woodsaw

国外网站扒图分享------集尘篇 - 美图欣赏 - 中国木工爱好者 - 手机版 - Powered by Discuz!

A broom has no cords or hoses to catch and will reach every corner of your shop.Instead of tripping over the vacuum or dust collection hose, just connect Woodstock International?s floor sweep to your dust collection system and sweep the debris away.

9" Press Screw. For making up veneer-press frames, case clamps or gluing jigs, this heavy-duty press screw is a sturdy, versatile jig.  The 1-3/8" x 1-5/8" swivel head is removable for easy installation or change-over. The threaded nut drives into a 1" round hole and may be further secured with screws. The screw diameter is 11/16".    Baked black enamel finish on malleable iron castings.

For making up veneer-press frames, case clamps or gluing jigs, this heavy-duty press screw is a sturdy, versatile jig. The x swivel head is removable for easy installation or change-over. The threaded nut drives into a rou

I needed to enlarge a previously drilled hole. Since I couldn’t use my hole saw’s pilot bit to center the hole, and I didn't have my drill press with me, I had to come up with a solution. What worked for me was to connect two hole saws together. One was the size of the existing hole. This saw "guided" the other hole saw that was the size of the hole I needed to drill.

I needed to enlarge a previously drilled hole. Since I couldn’t use my hole saw’s pilot bit to center the hole, and I didn't have my drill press with me, I had to come up with a solution. What worked for me was to connect two hole saws together.